11.
Fit rear fenders to the fender bars using
hardware (Fig. 5) also attach rear red
reflectors. Now attach the fenders to the
rear axle using hardware (Fig. 6). The fender
support bars fit to the V-shaped anchor
points on the axle near the tyres. You may
need to gently bend the fenders to align
over the tyres. Make sure both sides match
horizontally to look more aesthetically
pleasing .
Fig 5
Fig 6
12.
Attaching the seat / post. Add a little grease
to both ends of the seat post and attach
the thinner end to your seat, tightening
both sides of bolts , then slot post into the
seat mast. Secure using the seat post clamp
provided.
13.
Run the front brake cable up through guide
hole and into brake lever, now proceed
with setting front brake. Again if you
have no experience in this procedure, we
strongly recommend you seek professional
assistance especially with something as
important as your brakes. Below are some
basic instructions.
