2.
hold the alarm in the selected position and mark position of the holes in the alarm’s
housing. drill holes at location marks. note: exercise caution not to drill where damage
could occur.
3.
Fasten alarm to vehicle.
4.
Wire the alarm as instructed in the wiring diagram. the wires should be at least 18
gauge in size. make sure proper polarity is maintained when wiring. note: the back-up
alarm will not operate when its power connections are reversed. the back-up alarm needs
a dependable ground in order to work properly. make sure a solid ground connection to the
vehicle’s frame is achieved. Carefully route the wires to protect them from damage.
5.
Verify that the back-up alarm works properly. if the alarm does not work properly,
review step 4 for any errors.
6.
attach the Warning label provided to a clean surface, where it will be visible to
the operator.
important! do not spray any coating over the sound openings of the back-up alarm i.e.
pant, undercoating, etc. do not install the alarm or its wires close to any ignition wires.
do not wire in parallel with a relay or solenoid coil. all of these conditions may cause
your alarm to operate poorly.
WARRANty
buyers Products Co. warrants this product to be free from defects in material and work-
manship for a period of two years from date of manufacture. Parts must be properly
installed and used under normal conditions. any product which has been altered, including
modification, misuse, accident or lack of maintenance will not be considered under war-
ranty. normal wear is excluded. the sole responsibility of buyers Products Co. under this
warranty is limited to repairing or replacing any part or parts which are returned, prepaid,
and are found to be defective by buyers Products Co. authorization from buyers Products
Co. must be obtained before returning any part. no charges for transportation or labor per-
formed on buyers’ products will be allowed under this warranty.
buyers Products Co.
mentor, ohio
Made in Taiwan to Buyers’ exclusive specifications.
ba107 inst. rev a
