4
Thoroughly clean battery terminals. Make sure battery
terminals have no tarnish or corrosion.
DO NOT CONNECT WIRE HARNESS TO DAMAGED
OR CORRODED TERMINALS! IT MAY RESULT IN
OVERHEATING, LOST POWER AND POTENTIAL
CONTROLLER DAMAGE!
G.
Attach utility light (optional) to spreader hopper in desired
location. Connect as shown in Fig. 7. Use utility light kit part
number 3018009.
H.
See controller instructions for latest updates and error
codes.
Spreader Operation
1.
Different materials absorb moisture at different rates and
some materials may not perform as desired. Substitution
of an alternative material may be necessary for optimum
performance.
2.
When filling hopper use the supplied screen to prevent large
chunks of material and debris in the material to get into hopper
and cause damage.
3.
Material must never be left in hopper for an extended
period of time. Material will absorb moisture, bind, harden
and could prevent spreader from proper operation or may
damage the spreader.
4.
The SHPE1500 spreader is equipped with a dual independent
speed controller with warning indicators and a vibrator switch.
To start the spreader, press the ON-OFF switch. Switch will
illuminate. The auger will accelerate to full speed for 2 seconds,
then slow down to dialed speed. The spinner will accelerate to full
speed for 2 seconds, then slow down to dialed speed.
5.
To activate the vibrator press the vibrator switch ON. Vibrator
switch will illuminate.
6.
To stop the spreader, push ON-OFF switch to OFF position.
Material Flow Adjustments
Always use screen during spreader operation!
Various materials have different moisture absorption rate,
some materials may not perform as desired. Therefore, the
substitution of the alternate material may be necessary for
optimum performance.
SHPE1500 has two discharge openings in the bottom of the
hopper. Material flow through these openings can be controlled
using two sliding baffles. The spreader is shipped from the
factory with baffles adjusted for dry salt. In this setting rear
baffle has 4.0" opening and baffle in the middle of the hopper
has 2.0" opening. However if you are using a sand/salt mixture
or any chunky and hard to flow materials, adjust the rear baffle
opening to 3" and the baffle in the middle of the hopper to a 1"
opening.
IMPORTANT! -Always open rear (closer to gear motor
compartment) opening first. Always turn off power before
adjusting baffles!
Fig. 7
3014199
3006724
3035933
CB120PB
3001379
BATTERY POSITIVE
BATTERY NEGATIVE
