2
13.5"
2" x 4"
2" x 6"
FIT TO BOX
FIT TO BOX
8"
Safety Precautions
Fig. 2
Fig. 3
Fig. 4
1.
Read the entire Installation Instructions before operating this
spreader.
2.
Read all safety decals on the spreader before operating.
3.
Check to make sure all safety guards are securely mounted
into place before operating this spreader.
4.
Verify that all personnel are clear of the spreader spray area
before starting or operating this spreader.
5.
Do not over-load your vehicle beyond payload limits. If there
are any questions, contact the vehicle manufacturer.
6.
Do not adjust, clean, lubricate or unclog material jambs
without first turning off the spreader.
7.
Do not climb on or in the spreader during operation.
8.
Do not ride on the spreader while the vehicle is
in motion.
9.
Make sure the spreader is securely fastened to the vehicle in
accordance with this manual.
10.
Do not operate a spreader that is in need of maintenance or
repairs.
11.
Always disconnect the battery before removing or replacing
electrical components.
Installation Instructions
1. Mounting the Spreader onto the Vehicle:
A.
Remove the tailgate from the vehicle.
B.
Check truck’s bed for any sharp debris or foreign objects.
These can cut and seriously damage poly hopper.
C.
Lift spreader using tie downs. See Figure 1.
D.
Slide spreader forward until the steps on rear legs of the
spreader make contact with truck’s bed. Measure the distance
from the front of the truck bed to front of the hopper's front
legs. Fabricate spacer to fit between front of the spreader and
front of the bed as shown in Figures 2 & 3.
E.
Center the spreader from side to side on the vehicle.
Securely strap the spreader to the truck using four ratchet
straps as shown in Figure 4.
Verify with the vehicle’s manufacturer that the factory
installed anchor points are designed for tie-down such load.
Inspect straps and hardware after each time spreader is
loaded. Tighten straps and hardware if necessary.
WARNING
Observe the following Safety Precautions before, during and
after operating this spreader. By following these precautions and
common sense, possible injury to persons and potential damage
to this machine may be avoided.
Use Tie Downs
Fig. 1
