www.buyersproducts.com
Phone (440) 974-8888
Fax 800-841-8003
2
FCS031018150
FWL031058008
3000554
3036249
3036247
Installation
1.
Remove the two screws securing the box to the
pallet. Place the toolbox in desired location, the box
must be place on flat surface and must be completely
supported. There are several ways the box can be
mounted.
Option 1 (Fig. 1):
Use the mounting holes provide in the legs of the
box. Mark the location of the mounting holes. Drill
the holes with a ½" drill bit ensuring there are no fuel
lines, break lines, or any other obstructions in the way
that could cause harm to the vehicle. Remove box
and insert the blind fasteners provided (3036249).
Prestart the 5/16-8 x 1.5 bolts (FCS031018150) in the
blind fasteners to set and allow the crimping action
to deform to the underside of the mounting surface.
Once all blind fasteners are set remove bolts and
place box back into position. Re install all 5/16 bolts
along with flat washers (3000544) and lock washers
(FWL031058008). Secure bolts in place.
FCS031018150
FWL031058008
3000554
3036249
Fig. 1
Fig. 2
Fig. 3
Option 2 (Fig. 2):
Use the provided mounting plates (3036247). Position
the box in place in insert the mounting plates into
the legs of the box as shown in fig 2. Ensure the
edge of the holes in the mounting plate do not pass
beyond the edge of the toolbox legs. Follow the same
mounting procedure as option 1. Secure all bolts.
Option 3 (Fig 3.):
This option can be used if space is an issue from side
to side. Use the provided angled mounting plates
(3036248). Position the box in place in insert the
mounting plates into the legs of the box as shown in
fig 3. Ensure the edge of the holes in the mounting
plate do not pass beyond the edge of the toolbox
legs. Follow the same mounting procedure as option
1. Then fasten the rear of the mounting plate through
the back of the box. Be sure not to have any hardware
protrude through the box into the latch components.
FCS031018150
FWL031058008
3000554
3036248
3036249
Instructions For Inserting Cross-Nuts (Fig 4.)
To install the cross nuts drill a 1/2" hole in the desired
marked locations. Assemble the following supplied
components exactly as shown in Fig 4. Once
assembled snug all the parts together as shown
and insert into drilled hole. Hold the FHN038016028
(please note this nut does not engage the threads of
the bolt) nut with a 9/16" wrench so it does not turn.
Use a 1/2" wrench to turn the 3036604 bolt clockwise.
