3
CABLE FROM LIGHT
ACCESSORIES
FEED CABLE INTO
PROVIDED NOTCH.
NOTE: SIDE PLATE TO
BE TEMPORARILY
REMOVED TO ALLOW
CABLE WITH
PLUG ROUTING
5/16-18
NUT (4 PCS)
5/16-18 STUD
(4 PCS)
Fig. 9
Fig. 10
Fig. 11
Fig. 7
7.
INSTALLING ACCESSORIES TO THE LIGHT BAR MOUNT
Remove the Light Mount Top Plate (see Fig. 5) and install the
Light Bar (or other permanently mounted accessory) to the
Mount Plate of Light Bar Mount.
NOTICE: Ensure that no
hardware protrudes more than 3/8" beyond the bottom of
the Mount Plate. The Light Bar Mount Plate comes with an
array of existing holes.
You may need to modify these or drill
new holes to attach your accessory.
a.
Direct wiring the Light Bar or other accessory
i.
Drill the hole for wire/cable access from the top centered
in the middle of plastic surface of the Light housing to
accommodate the cable. See Fig. 8. Make sure the chosen
hole location for cable entry will not interfere with 3rd Brake
Light attached.
NOTE: Determine hole size and the best
location. For the best results, use a RTV sealant (not
provided) to prevent water intrusion around the drilled
hole and cable.
ii.
Feed the wire from the Light Bar or accessory through
the Light Bar Mount Plate, through the hole drilled into the
plastic Light Housing, and into the truck from the top. Feed
cable inside the truck frame opening and extend it to light
controls.
iii.
Once everything is aligned and the wire is positioned as desired
and the Light or accessory is functioning properly, secure Light
Bar Mount Plate using six #10-32 x3/8 screws (Fig. 8).
b.
Using prewired auxiliary plug
i.
Feed the wire with plug from the Light bar or accessory
through the Light Bar Mount Plate oval hole and into the
provided notch (Fig. 9). Side Plate has to be removed
temporarily to allow wire with plug routing. Re-install plate
when finished.
ii.
Once everything is aligned and the wire is positioned as
desired and the harness is routed into the truck thru door
or window, the Light or accessory is functioning properly,
secure Light Bar Mount Plate using six #10-32 x3/8 screws
(Fig.8). Be sure to tighten all hardware firmly.
Fig. 6
SECURE TOP PLATE
WHEN DONE
WITH 6 SCREWS
FEED CABLE INTO
DRILLED HOLE.
SEAL WITH RTV
CABLE FROM LIGHT ACCESSORY
EXTEND CABLE
TO CONTROLS
Fig. 8
8.
With the Light Bar Mount is in position, reinstall the 3rd Brake
Light by first reconnecting the harness and then reinserting the
4 original mounting screws. See Figure 10, 11.
9.
Verify the function of the 3rd Brake Light.
