6. Operation
■
STARTING ENGINE
1. Untwist and remove the fuel cap and oil cap.
Rest the cap on a dustless place.
2. Fill the fuel tank and oil tank to 80% of the full
capacity.
3. Fasten the fuel cap and oil tank securely and
wipe up any fuel spillage around the unit.
4. Put the switch to the "I" position.
5. Pull out the choke knob. The choke will close
and the throttle lever will then be set in the
starting position.
6. Continuously push the primer bulb until fuel
comes in the bulb.
(1) Engine switch (2) Choke knob (3) primer
bulb (4) Fuel tank cap (5) Oil tank cap
When restarting immediately after stopping the
engine. Set choke in the open position
Once the choke knob has been pulled out, it will
not return to the running position even if you press
down on it with your finger. When you wish to
return the choke knob to the running position,
press the throttle lever instead.
7. Push the front handle guard down toward the
front to activate the chain brake.
8. While holding the saw unit securely on the
ground, pull the starter rope vigorously.
9. When firing occur, press the throttle trigger to
allow the choke return to the running position and
