-2-
CROSS ARM ASSEMBLY
G
6. Repeat step 5 for the end
of the CPK cross arm
Repeat steps 2 thru 6 for and
assembly the second cross arm.
FINAL ASSEMBLY
G
7. Place one u-bolt around
the middle of tube (AA) as
shown and pass the ends
through the holes of
reinforcing (AB) and tube
(AC) of one of the cross
arms. Secure finger tight
with a lock washer and hex nut
G
8. Repeat step 7 with the remaining cross arm.
G
9. Position the cross arms so they are 90
/
to one
another. Securely tighten the hex nuts on both
cross arms.
NOTE: DO NOT OVER TIGHTEN THE U-BOLTS AS
THEY WILL CUT INTO THE TUBING AND WEAKEN
THE ASSEMBLY.
G
10. Place a wire clamp (AF) on the of each cross
arm tube (AE). Secure each with 3/4" screw,
lock washer and hex nut.
G
11. Place a plastic protective cap 3/8" over the end
of each cross arm.
G
12. Insert a 3/4" screw through wire clamp (AF).
Place the lugs from two spreader wires (AG)
over the screw and secure with a lock washer
and hex nut.
G
13. Repeat step 12 for the
remaining wire clamps.
G
14. Attach connector
assembly (AH) around the
top of tube (AA). Secure
with a 1-1/4" screw, lock
washer and hex nut.
Tighten any loose hardware but
do NOT over tighten the u-bolts. The CPK is light enough to remain in place even
in strong winds and you don’t want to crush tube (AA). Allow a little slack in the
connecting wire so that the cross arms remain straight and unbowed.
