S-HOOK
Step 3:
Assemble the spring steel
frame by joining the sections to form an
“X” and place the frame on top of the
tent ensuring the cross of the frame is
placed at the tie tabs located at the
centre (see illustration)
Step 4:
Loop the tie tabs around the cross of the frame
and secure.
Step 5:
Locate the “s”-hooks
attached to the two corners
of the tent and clip these
under the “o”-ring at the
bottom of each leg of the frame.
Step 6:
Clip all the
“s”-hooks located along the
sides of the back panel onto
the frame all the way to the
centre.
Step 7:
Secure the tent
to the ground by
hammering the
stakes through the
D-rings located on all four
sides of the tent.
Step 8:
With a person in each
front corner push the legs to the
tent body and repeat Step 5.
OPEN
Step 9:
Ensure the door on the
front panel is zipped open.
S-HOOK
Step 10:
Stand in the open door
and clip all the “s”-hooks located
along the sides of the front panel
onto the frame.
Step 12:
Secure a guy rope to the frame at each
rear corner of the tent to anchor it in case of strong
winds.
Step 13:
At the front section of the verandah, locate
the canvas sleeve between the two corners and
slide the ridge pole through the sleeve.
Step 15:
Secure the verandah with the guy ropes, by
sliding the loop of the guy rope over the pin of the
uprights and staking it out at a 45° angle.
Step 14:
Insert the upright pole through the holes of
the ridge pole and through the eyelet on the
verandah.
Ridge pole
socket
Step 16:
Roll the
fasten at the
Pull window
through the end
into the ground.
OR
Upright poles
Ridge pole
flaps down at
an angle, put
the stakes
of the rope and
push the stakes
window
flaps up and
top.
Webbing strap
with hook
on the frame and tighten.
webbing straps with the hook through the steel ring
there is a webbing strap with a hook. Hook the
the top of the bow tent. On each corner of the flysheet
Step 11:
Pull the flysheet (canopy and verandah) over
FOLDING INSTRUCTIONS:
Step 1:
Ensure the tent is clean and dry before starting
the folding process.
PLEASE NOTE:
When cleaning your tent use
water and light detergent to remove any dirt from
the canvas
Step 2:
Once the canopy and verandah has been
removed unclip all the “s”-hooks, loosen the tie
tabs and fold the tent as per following steps:
2.1:
Pull the top point of the tent to
the left so that the right panel (side with
window) is completely open
2.2:
Pull the top point of the tent to the
back so that the front panel (side with
door) is completely open
2.3:
Pull the top point of the tent to the
right so that the left panel (side with
window) is completely open
2.4:
Pull the top point of the tent to the
front so that the back panel (blank side)
is completely open.
Step 3:
Unclip the two front legs then the two back legs
of the frame and remove all the stakes.
in the illustration)
Step 4:
The tent should now be laying flat.
fold the first third of the
folding line
Now
tent (see
FOLD LINE
FOLD LINE
Step 5:
Fold the second third (see
folding line in the illustration)
Step 6:
Roll the tent as tight as
brushing the tent as
dirt is rolled up with the roof.
possible
you’re rolling ensuring no
