Bushranger MC-HTS-2, Owner'S/Operator'S Manual

Page: 7 / 16

＿
6
＿
Detaching
1 First, loosen the clamping knob before
detaching the shaft assembly to the shaft
coupler.
2 Pull out the shaft assembly from the shaft
coupler while holding the positioning lever
down.
3 Note: Do not over loosen the clamping knob
or it may fall out.
Clamping
Knob
Shaft Assembly
Positioning
Lever
Removal
Push down
Loosen
Idle Speed Adjustment
This Multi-Cutter is equipped with non-adjustable fuel mixture carburetor. The idle speed is the only adjust-
ment for the operator.
Please see your Multi-Cutter Power Unit Owner’s/Operator’s Manual.
The cutting attachment may be rotating during idle speed adjustment. Wear the recommended
personal protective equipment and observe all safety instructions. Keep hands and body away
from the cutting attachment.
If idle speed adjustment is necessary, and after adjustment the cutting attachment rotates or the
engine stalls, stop using the Multi-Cutter immediately!
Contact your local authorized BUSHRANGER Dealer for assistance and servicing.
WARNING
POTENTIAL HAZARD
・
Engine must be running to make carburetor adjustments.
・ When engine is running, attached tool and other parts are moving.
WHAT CAN HAPPEN
・
Contact with moving attached tool or other moving parts could cause serious personal injury or
death.
HOW TO AVOID THE HAZARD
・ Keep hands, feet and clothing away from attached tool and other moving parts.
・ Keep all bystanders and pets away from unit while making carburetor adjustments.