| Max Air III
|Max Air III
Page 6
Page 7
Tyre Inflation
Tyre Deflation
Attach one end of hose quick connect coupler to air compressor & the
other end to the Inflator/deflator gun.
Fit connector onto tyre valve stem.
Check to make sure deflator collar lock is disengaged.
Turn compressor switch ‘On’ & hold trigger down to begin inflation. When
desired pressure is reached, release trigger.
Pull back rubber surround on digital gauge body to reveal location of
battery cover.
Remove battery cover and fit / replace batteries ensuring correct polarity.
Refit battery cover and ensure it is clipped in correctly.
Refit rubber surround to gauge body. Gauge is ready to use.
Remove the temporary protective red plug from the air inlet port.
Screw in the air filter unit & hand tighten. Do not use Teflon tape or
lubricants on the thread.
Unscrew the top lid to check if the element is correctly in place.
Fit connector onto tyre valve stem
Press Bleeder Valve button on tyre gun.
When desired pressure is reached, release valve.
1.
2.
3.
4.
1.
2.
3.
4.
1.
2.
3.
1.
2.
3.
The air compressor comes originally packed without the air filter unit installed.
Follow Procedure below for correct installation:
Digital Gauge Battery Replacement
Fitting Air Filter Unit
Note:
The trigger lock on the inflator gun can be used to allow hands free tyre
inflation during long fills. Pay careful attention when using the trigger lock to ensure
that the tyres are not overfilled past the manufacturer’s maximum pressure rating
Note:
To release pressure, Turn OFF compressor, hold down trigger on tyre gun until
all pressure released. Now disconnect hose.
In-line Presure Gauge
•
The large in-line gauge provides convenient monitoring of tyre pressure when
deflating or inflating. This eliminates switching back & forth between a hand-
held pressure gauge & the compressor.
•
Please note that during inflation & deflation, due to air velocity, the pressure
gauge cannot provide accurate readings. Momentarily stop inflation to
obtain accurate pressure readings.
•
Do not disassemble. Do not attempt repairs or modifications. Your warranty
will be void if this instruction is ignored.
•
Do not use this product in an area where it can fall or be pulled into water or
other liquids.
•
The base tray is fitted to place a barrier between the compressor & sandy or
dusty ground, plus provide a stable operating platform, therefore keep the
tray clean at all times during use.
•
Use this compressor with 12Volt DC power only.
•
This product should never be left unattended during use.
•
Pay careful attention when using the trigger lock on the inflator gun to ensure
that the tyres are not overfilled past the manufacturer’s maximum
pressure rating.
Important Safety Instructions
Summary of Contents for Max Air III 55x23
Page 1: ... Max Air III Page 1 ...
