![background image](http://html.mh-extra.com/html/bushranger/ht241/ht241_owners-operators-manual_2835620015.webp)
- 14 -
STORAGE
For long-term storage of the Hedge Trimmer, empty the fuel tank
into a suitable fuel storage container. Pump the primer bulb on
the carburetor until all fuel is discharged through the clear fuel
return hose. Run the engine to remove any fuel that may remain
in the caburetor. Perform all regular maintenance procedures and
any needed repairs. Remove the spark plug and squirt a very
small amount of oil into the cylinder. Pull the starter cord once.
CAUTION
Oil may squirt out of the spark plug opening while pulling the starter cord. Protect your eyes and keep your
face away from the spark plug opening. Slowly pull the starter cord to bring the piston to the top of the
cylinder (TDC). Reinstall the spark plug. Liberally lubricated the blades with a light (#10 wt.) oil. Store the
Hedge Trimmer in a dry place away from excessive heat, sparks or open flame.
LUBRICATION: GEARCASE AND BLADES
The gearcase has a felt wick located at the blade opening. As the
Hedge Trimmer is used, the grease within gearcase becomes
very soft. The reciprocating blades constantly draw small amounts
of grease between the blade contact surfaces for additional
lubrication. If the gearcase is not lubricated at the recommended
intervals, a gearcase failure will occur due to a lack of lubrication.
Gearcase failures due to improper maintenance are not covered
by BUSHRANGER warranty. The gearcase and blades should be
lubricated after each 15 hours of use. The amount of grease to be
applied is about 15g. But then, stop applying when grease comes
out from the blade opening.
NOTE:
If the Hedge Trimmer is used under severe conditions such as high ambient temperatures (above
25°C) or for extended continuous periods of operation, the gearcase and blades must be lubricated every
2 hours.
Lubricate the gearcase at the grease fitting with a good quality #2 lithium-base grease. Lubricate the
blades using a light (#10 wt.) oil.
GENERAL CLEANING AND TIGHTENING
The BUSHRANGER Hedge Trimmer will provide maximum performance for many, many hours if it is
maintained properly. Good maintenance includes regular checking of all fasteners for correct tightness,
and cleaning of the entire machine. Pitch and gum deposits should be removed from the cutting blades
daily. Adjustment of the cutting blade tension should be checked regularly. Refer to page (9) for instructions
to adjust cutting blades.
OIL
GREASE FITTING
FOR GEAR CASE