- 12 -
REGULAR MAINTENANCE
AIR FILTER
Maintenance Interval:
The air filter should be cleaned daily or more often when working
in extremely dusty conditions and replaced after every 100 hours
of operation.
Maintenance:
Remove the filter cover and the foam element. Clean the foam
element with warm, soapy water. Let the element dry completely.
Apply a light coat of SAE 30 motor oil to the foam element and
squeeze out all excess oil. Reassemble the foam element and
filter cover.
FUEL FILTER
Maintenance Interval:
The fuel filter should be replaced after every 100 hours of
operation.
Maintenance:
The fuel filter is attached to the end of the fuel pick-up hose inside
the fuel tank. To replace the fuel filter, first make sure the fuel tank
is empty. Remove the fuel cap. Using a wire hook, gently pull
the fuel filter out though the fuel filter opening. Grasp the fuel
hose next to the fuel filter fitting and remove the filter
but do not
release the hose.
While still holding on to the fuel hose, attach
the new fuel filter.
Drop the fuel filter back into the fuel tank. Make sure that the fuel
filter is not stuck in a corner of the tank and that the fuel hose is
not doubled over (kinked) before refueling.
WARNING
When the hedge trimmer is stopped for servicing, inspection or storage, shut off the power source,
disconnect the spark plug wire from the spark plug and make sure all moving parts have come to a stop.
Allow the hedge trimmer to cool before making any inspections, adjustments, etc.
SPARK PLUG
Maintenance Interval:
The spark plug should be removed from the engine and checked
after each 25 hours of operation and replaced after every 100
hours of operation.
Maintenance:
With the engine at ambient (room) temperature, twist the high
tension lead boot on the spark plug back and forth a couple of
times to loosen boot then pull the boot off of the spark plug.
Remove the spark plug. The electrodes can be cleaned with a
stiff brush. Adjust the electrode air gap to 0,6-0,7 mm (0,024-0,028 in.). Replace the spark plug if it is oil-
fouled, damaged or if the electrodes are worn down.
Do not overtighten the spark plug when installing.
The tightening torque is 10.7-16.6Nm (95-148 in. lbs.). Reinstall the boot of the spark plug.
FOAM ELEMENT
FILTER COVER
WIRE
FUEL TANK
FUEL FILTER
0,6 - 0,7 mm
(0.024-0.028 inches)
TIPS