INSTALLING THE BATTERIES AND SD CARD
Before you begin learning how to use your
Prime L20 Trail Camera
,
you will first need to install a set of batteries and insert an SD card.
Although that may only take you a minute, there are some important
notes about both batteries and SD cards you should be aware of, so
please take the time to read the following directions and cautions:
Loading Batteries
After opening the latch on the right side of the
Prime L20 Trail
Camera
, you will see that the
Prime L20 Trail Camera
has a battery
release button. Depress this button and a battery tray will drop out of
the bottom of the camera. The battery tray will stop about ½ inch out
of the device, this is a latch system to prevent the tray from dropping
onto the ground. Just apply a little pressure when pulling and the tray
will release. The battery tray has six battery slots. Install a full set of 6
batteries. Be sure to insert each battery with correct polarity (negative
or “flat” end against the long spring of each battery slot).
Bushnell recommends using a full set of new
lithium AA (Energizer® brand) or alkaline AA
batteries. NiMh Rechargeable batteries are not
recommended, as the lower
voltage they produce can cause
operational issues.
You can also connect an
optional Solar Panel accessory (model# 119986C
–please visit www.bushnell.com for more information)
to the “DC In” jack at the bottom of the
Prime L20
Trail Camera
(other external power supplies should
not be used, as the camera and/or display may not
function correctly). If the solar panel is connected
and AA batteries are installed, the
Prime L20 Trail Camera
will be
powered by the solar panel’s rechargeable lith-ion battery, as long as
it provides adequate voltage (if not, the camera will switch to battery
power). The solar panel’s battery will power the camera at night.
6