9
and elevation adjustments (E), using the supplied
large hex wrench/screwdriver (K), to align the red
dot with the target as seen along the barrel.
3. You should then fire a test shot to determine the
point of impact of your weapon. If you are not
hitting your aiming point (the center of the target)
make an adjustment by turning the windage or
elevation screw(s) in the direction you want the
bullet to move. The chart on the next page will
aid you in determining the proper amount of
adjustment necessary depending upon the range
at which you are shooting.
REPLACING THE BATTERY
Y
our new Bushnell First Strike electronic sight is
powered by one 3V “coin-style” lithium battery, Type
2032 (J) (pre-installed). Should your reticle grow dim
or not light at all, you will need to replace the battery.
To install a new battery, use the provided small hex
wrench (L) to loosen the two bolts (G) on the top panel.
Remove the top section of the sight and insert the
battery “+” side up as shown in the Parts Guide. Align
and replace the top section and tighten the bolts (G).
Adjusting the Windage
(F)
