User Instructions
Using your appliance
To operate the dishwasher:
1. Make sure the water inlet and drain hoses are correctly and securely connected.
2. Push the door release button to open the door.
3. Fill the detergent, water softener and rinsing aid to the dishwasher.
4. Draw out the lower and upper basket. Load the dishes on the dish rack and cutlery inside the cutlery
basket. Make sure that the rotating spray arm can turn freely all the way round. If necessary remove
any obstacles.
5. Open the water supply.
6. Select the desired washing program by pressing the Program button. Close the door firmly.
The dishwasher will start to work in 3 seconds.
7. The dishwasher is designed to stop if the door is opened accidentally during operation.
8. The dishwasher stops automatically at the end of the program. You will hear 8 sec. buzzer sound. The
power pilot light will remain illuminated until the power is switched off.
9. After washing, dishes should be allowed to cool down for about 15 minutes as they are hot to handle.
Dishes will cool quicker if the door is opened slightly.
10. Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
11. After unloading the dishes, remove and clean the filter and return to its position.
Note:
This is normal when you noted small amount of water being pumped-out from the drain hose prior
to the start of a wash cycle. This is because the pump retains a small amount of water from the previous
cycle.
Program Selection Change
You can modify the washing program when the dishwasher just runs for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled.
Press the button of the desired program more than 3 seconds until it's indicator is on, the machine will
operate in new program after 10 seconds.
Note:
If you open the door during the washing cycle, the machine will pause. When you close the door,
the machine will resume operation after 10 seconds.
The program lights show the state of the dishwasher:
All program lights off – Stand by
One of the program lights on – Pause
One of the program lights blinking – Run
Delay function
After selecting the wash cycle program, you can set the desired delay start time by pressing the delay
button. You can select 1-24h from the program. The dishwasher will start operation after the selected
delay time is elapsed.
17
