Bush SB03, Instruction Manual

Page: 16 / 32

Using your Soundbar
Let’s get started
Using your Soundbar
16
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Power on
Press and release the Power button on the top of the
product or on the remote control. Your Soundbar will
switch on in Bluetooth mode. A tone will sound and
the blue LED behind the front lens will flash quickly
whilst your product searches for Bluetooth devices.
Standby mode
Press and release the Power button on the top of the
product or on the remote control. Your Soundbar will
go to Standby mode. The red LED behind the front lens
will flash slowly in Standby mode.
Note : This product is designed to go to
STANDBY mode automatically after 15 MINUTES
(approximately), if it does not receive an audio signal.
Press and release the Power button on the Soundbar
or on the remote control to switch your product
back on again.
Change the mode
Press and release the Source button on the top of the
Soundbar or on the remote control to change between
Bluetooth, Aux in and TV modes.
The blue LED behind the front lens will move to
indicate the current mode.
Note
: Approximately 60 seconds after you have
selected the mode (Bluetooth/Aux in/TV), the LED
indicator will turn off. When you press any button
on the remote control, the LED will turn back on
again, to indicate the current mode. A further press
of the remote control will activate the function
required.
Adjusting the volume
Vol- (on the soundbar)/ (on the remote)
• Press and release to decrease the volume in steps.
• Press and hold to progressively decrease the
volume.
Vol+ (on the soundbar)/ (on the remote )
• Press and release to increase the volume in steps.
• Press and hold to progressively increase the volume.
Note
: You will hear an audible alert when the
minimum or maximum volume level has been
reached.
Bass or Treble enhancement
The Bass and Treble settings each range from -3 to +3.
1.
Press and release the Bass or or - button
on the remote control to adjust the Bass or Treble
as appropriate.
2.
Press and release the Reset button on the remote
control to reset your Soundbar to its EQ, Bass and
Treble settings.
Equaliser (EQ)
There are 4 EQ settings available on your Soundbar.
These are Music, News, Movie* and Flat.
* Movie is the default setting and your Soundbar will be
set to this when you first use your product.
1. Press and release the EQ button on the remote
control to cycle through the available options.
2. Press and release the Reset button on the remote
control to reset your Soundbar to its EQ, Bass and
Treble settings.