LATITUDE SERIES
8
Display the Signal Strength
Note:
Stations with signal strength below the minimum signal level will not provide a steady stream of audio.
1. Refer to the method of ‘
View Station Information
’ outlined on the previous page to activate ‘Signal Strength’. A
signal bar will be displayed as shown below.
The indicator on the signal bar shows the minimum acceptable signal
level.
Manual Tune:
1. Press
MENU
Button
Turn the
SELECT
dial to Manual tune
Press the
SELECT
dial to confirm, the display will
show the channel number and frequency as below
2. Turn the
SELECT
dial to step between the channels and then press the
SELECT
dial select the current channel.
Note
: If there is a multiplex corresponding to this channel and frequency, then the display will show a tuning meter with the
signal strength and the multiplex name after a few seconds.
3. To exit ‘
Manual tune
’ press the
SELECT
dial again.
DRC (Dynamic Range Control)
You can set the level of the compression of stations to eliminate the differences in dynamic range or sound level
between radio stations.
Note:
When DRC is set to
off
it indicates no compression, when DRC is set to
low
it indicates little compression, and
when DRC is set to
high it
shows maximum compression.
1. Press
MENU
Button
Turn the
SELECT
dial to the
DRC
menu
Press the
SELECT
dial to confirm.
2. Turn the
SELECT
dial to select your ideal DRC Mode. Press the
SELECT
dial to confirm.
Prune
Note
: Performing a prune of stations will remove inactive stations from the station list.
1. Press the
MENU
Button
Turn the
SELECT
dial to the
Prune
menu
Press the
SELECT
dial.
2. Turn the
SELECT
dial to select
Yes
, and then press the
SELECT
dial
to confirm.
Using DAB+ Radio
