Bush LATITUDE SERIES, Manual

Page: 12 / 15

LATITUDE SERIES
12
Set Alarm

Note : Ensure that the time is set correctly before you set one of the Alarms.
The process to set an alarm is as follows:
1. Press the
MENU
Button  <
System
>  <
Alarms
>.
2. Press the
SELECT
dial to confirm, and your radio will display ‘
Alarm 1 Setup
’. To set alarm2,
t
urn the
SELECT
dial to then press the
SELECT
dial to select ‘
Alarm 2 Setup
’.
3. Once you have selected the alarm

Press the
SELECT
dial
twice
, then follow the instructions on the display
to configure the following parameters. Once each is set, press the
SELECT
dial:

Alarm State
: Off/ On, press the or buttons to select On or Off.

On Time
: 00: 00 (alarm sounding time) Select the alarm time in hours, then minutes. Press the
SELECT
dial
to confirm each once confirmed.

Duration time
: 15/30/45/60/90minutes (alarm sounding lasting time) Select how long you wish for the alarm
to sound for.

Source
: Buzzer/DAB/FM Select the audio that you wish to hear when the alarm sounds.

Alarm Frequency
:
Daily, Once, Weekends or Weekdays. Selects how often you wish for the alarm to sound.

Alarm Volume
: Press the or button to select your desired alarm volume, then press the
SELECT
dial
to confirm.
Once all parameters are confirmed your radio will display ’
Alarm saved
’.
To Operate SNOOZE

When the Alarm sounds and you wish to activate the snooze function press the
SELECT
dial.

The radio will go into Standby mode for a period of 5 minutes. It will display a five minute count down and
once the 5 minutes is over, the alarm will sound again.

The Alarm will sound again after the snooze time has elapsed, at this time, if you press the
SNOOZE
button
again and it will count down for another 5 minutes, or you also can press the
POWER
button to stop the
alarm.
To Turn Off Alarm

Note : To turn the alarm off temporarily, when the alarm sounds, press the POWER button. To turn it off permanently, follow
the instructions 1 and 2 for setting an alarm as outlined above, and select Off.
Refer to steps1 and 2 outlined above. Use the or Button to select ‘Off’, and then press the
SELECT
dial to
confirm.
Display Software Version
1. Press the
MENU
Button

<
System
>

<
SW version
>.
.
2. Press the
SELECT
dial to confirm. You will now be able to view the software information of this radio.
Troubleshooting and Technical Specification