Bush DWINT15LC, Instruction Manual

Page: 34 / 40

Product support 34
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Product support
Help is always at hand
Troubleshooting
FAULT POSSIBLE CAUSE TROUBLESHOOTING
The programme does not
start.
Your Dishwasher is not plugged in. Plug your Dishwasher in.
Your Dishwasher is not switched on.
Switch your Dishwasher on by pressing the On/Off
button.
Fuse blown. Check your indoor fuses.
Water inlet tap is closed. Turn on the water inlet tap.
Your Dishwasher door is open. Close the Dishwasher door.
Water inlet hose and machine filters are
clogged.
Check the water inlet hose and machine filters and
make sure they are not clogged.
Water remains inside the
machine.
Water drain hose is clogged or twisted. Check the drain hose, then either clean or untwist it.
The filters are clogged. Clean the filters.
The programme is not finished yet. Wait until the programme is finished.
Machine stops during
washing.
Power failure. Check mains power.
Water inlet failure. Check water tap.
Shaking and hitting noises are
heard during a wash operation.
The spray arm is hitting the dishes in the lower
basket.
Move or remove items blocking the spray arm.
Partial food wastes remain
on the dishes.
Dishes placed incorrectly, sprayed water not
reaching affected dishes.
Do not overload baskets.
Dishes leaning each another.
Place dishes as instructed in the section on loading your
dishwasher.
Not enough detergent used.
Use the correct amount of detergent, as instructed in
the programme table.
Wrong wash programme selected.
Use the information in the programme table to select the
most appropriate programme.
Spray arms clogged with food waste.
Clean the holes in the spray arms with thin objects.
Filters or water drain pump clogged or filter
misplaced.
Check the drain hose and filters are correctly
fitted.