Bush DWINT15LC, Instruction Manual

Page: 26 / 40

Using your Dishwasher
26
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
These products should be used according to the
manufacturer’s instructions.
Never put combined detergents into the interior
section or the cutlery basket.
Combined detergents contain not only the detergent
but also rinse-aid, salt replacement substances and
additional components depending on the
combination.
We recommend you do not use combined
detergents in short programmes. Please use powder
detergents in such programmes.
If you encounter problems when using combined
detergents, please contact the detergent
manufacturer.
When you stop using combined detergents, make
sure that water hardness and rinse aid settings are set
to correct level.
5.7 Filling the Detergent
Push the latch to open the dispenser and pour in
the detergent.
Close the lid and press it until it locks in place. The
dispenser should be refilled just before the start of
each programme. If the dishes are heavily soiled,
place additional detergent in the pre-wash
detergent chamber.
Rinse-aid makes dishes sparkle and helps them to
dry without spotting. Rinse-aid is required for
stain-free utensils and clear glasses. Use only
rinse-aid for domestic dishwashers.
5.9 Rinse-aid Usage
5.10 Filling the Rinse-aid and setting
5.8 Using Combined Detergents
DETER
GENT
To fill the rinse aid compartment, open the rinse-aid
compartment cap. Fill the compartment with rinse aid to
the MAX level and then close the cap. Be careful not to
overfill the rinse aid compartment and wipe up any spills.
In order to change the rinse aid level, follow the below
steps before turning on the machine:
• Push the programme button and hold it down.
• Turn on the machine.
• Hold the Programme Button down until all leds
blink twice. Rinse aid setting follows water hardness
setting.
• The machine will display the current setting.
• Change the level by pushing the programme button.
• Switch off the machine to save the setting.
The factory setting is “4”.
If the dishes are not drying properly or are spotted,
increase the level. If blue stains form on your dishes,
decrease the level.
Level Brightener Dose Indicator
1 Rinse-aid not
dispensed
P1-P5 LEDs are on
2 1 dose is
dispensed
P2-P5 LEDs are on
3 2 doses are
dispensed
P3-P5 LEDs are on
4 3 doses
dispensed
P4-P5 LEDs are on
5 4 doses
dispensed
P1-P4-P5 LEDs are on