Bush DWINT125W, Instruction Manual

Page: 21 / 38

Getting the most from your appliance
2. Push the door release button to open the door.
3. Fill the detergent, water softener and rinsing aid to
the dishwasher.
4. Draw out the lower and upper basket. Load the
dishes on the dish rack and cutlery inside the cutlery
basket. Make sure that the rotating spray arm can turn
freely all the way round. If necessary remove any
obstacles.
5. Open the water supply.
6.
7. The dishwasher is designed to stop if the door is
opened accidentally during operation.
8. The dishwasher stops automatically at the end of
the program. You will hear 8 sec. buzzer sound. The
power pilot light will remain illuminated until the
power is switched off.
9. After washing, dishes should be allowed to cool
down for about 15 minutes as they are hot to handle.
Dishes will cool quicker if the door is opened slightly.
10. Empty the lower basket first and then the upper
one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
11. After unloading the dishes, remove and clean the
filter and return to its position.
Note: This is normal when you noted small amount of
water being pumped-out from the drain hose prior
to the start of a wash cycle. This is because the pump
retains a small amount of water from the previous
cycle.
To operate the dishwasher:
Program Selection Change
Note: If you open the door during the washing cycle,
the machine will pause. When you close the door, the
machine will resume operation after 10 seconds.
The Display window shows the state of the
dishwasher:
a)
is on but not blinking
----stand by or pause
b)
blinking----Running
Delay function
After selecting the wash cycle program, you can set the
desired delay start time by pressing the delay button. You
can select 3/6/9h from the program. The dishwasher will
start operation after the selected delay time is elapsed.
Functions Simple everyday use
Using your dishwasher
You can modify the washing program at any
time. Please check the detergent dispenser. If it is
opened, refill with the detergent before start the
new program.
1. Make sure the water inlet and drain hoses are
correctly and securely connected.
21
Press the ON/OFF button, press the Program
button to select a desired wash cycle, then close
door ,the machine will work after 10 seconds.
Open the door, the dishwasher will be paused, then press
the Program button more than 3 seconds to cancel the
current program , you can change the program to the
desired cycle setting
Program indicator is on but
Program indicator is blinking
Example : Set normal program with 3 hours delay setting.
Setting steps
Add detergent and salt if necessary
Put all dishes in and close the door
Press On/Off button once
Continue to press program button until the indicator
light for icon illuminates.
Continue to press delay button until the indicator light
for 3h illuminates.
Close the door to start.