Bush BT26, Instruction Manual

Page: 9 / 17

16
17
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Fabric Speaker
Using your Fabric Speaker
Using your Fabric Speaker
Let’s get started
Using your Fabric Speaker
Let’s get started
Power on
After you have connected the power to the Fabric speaker, the status LED will start to flash
quickly whilst the product searches for bluetooth devices. If the Fabric Speaker does not
receive an audio signal for approximately 20 minutes it will go to Standby mode.
Standby mode
If the Fabric Speaker does not receive an audio signal for approximately 20 minutes, it will
go to Standby mode and the status LED will flash slowly. Press and release the Power
button to turn the product back on again.
Status LEDs
Blue flashing quickly
: Searching for BT devices
Blue flashing slowly : BT standby mode
Blue steady on : BT connected
Red steady on : Aux in mode
Red flashing slowly : Aux in standby mode
Power off
Press and release the Power switch to go to Standby mode and then switch off at the wall
socket to power off.the product completely
Connect to a Bluetooth device
1. With the Status LED flashing blue quickly, whilst your product searches for Bluetooth
devices:
2. On the device that you would like to connect to your Fabric Speaker via Bluetooth (e.g.
iPhone/iPad/Android/other phone/Tablet/Computer), turn on Bluetooth connectivity
and ensure that it is ‘discoverable’.
Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.
3.
Select to ‘Add new device’, if necessary.
Note: Some products will automatically search for a new device and so the ‘Add new
device’ option is not available.
4. When found, your Fabric Speaker will be displayed as ‘BUSH BT26’. Select the device
name to begin pairing.
Note:
If your device requests a password, please enter ‘0000’ to complete the device
pairing.
5. When pairing is complete the LED will change to be continuously on (not flashing) and
‘Audio device connected’ will be announced.
6. Now that you have paired your device with the Fabric Speaker, it will connect to it
when it is within range, which is about 10 metres or less (33 feet or less), line of sight.
7. Your device will remain paired with the Fabric Speaker unless you decide to disconnect
or ‘unpair’ it.
Adjusting the volume
• Press and release to increase the volume in steps.
• Press and hold to progressively increase the volume.
Volume-
• Press and release to decrease the volume in steps.
• Press and hold to progressively decrease the volume.
Note: You will hear an audible alert and the status LED will quickly flash when the
minimum or maximum volume level has been reached.