Bush BT26, Instruction Manual

Page: 4 / 17

Safety information
Important - Please read these instructions fully before
installing or operating
Safety information
Safety information
6
7
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Safety information
Important
- Please read these instructions fully before
installing or operating
General safety information
Keep the product and all its parts out of reach of small children.
This product is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety.
• Do not attempt to open the product. This product does not contain any user
serviceable parts. Unauthorised handling of the device may damage it and will void
your warranty.
• Do not use your Fabric Speaker emergency/intensive care medical equipment; or
during an electrical storm.
To avoid possible hearing damage, do not listen to this Fabric Speaker at
high volume levels for long periods of time. Always keep the volume within
reasonable limits.
Power source
Only use the power supply that came with the product. Using an unauthorised power
supply will invalidate your guarantee and may irrecoverably damage the product.
Disconnect your Fabric Speaker from the mains power supply during thunderstorms.
Always check that you have completely switched off your Fabric Speaker, before you
change or disconnect the power supply.
Where the mains power plug or an appliance coupler is used as the disconnect device,
the disconnect device shall remain readily operable.
If the Fabric Speaker will not be used for a long period of time, make sure that the mains
power is unplugged.
Moisture and water
• Do not leave it in low temperatures as moisture can form inside the product, which
may damage the circuit board.
Ventilation
• Do not block or cover slots, holes or openings on the product by placing on soft
furnishings such as carpets, rugs or beds as these are provided for functionality and/or
ventilation to ensure safe operation of the product.
Heat sources and flames
Do not leave it in high temperatures as electronic devices and plastic parts may warp in
heat.
Keep it away from bright sunlight or heat sources, such as a radiator.
No naked flame sources, such as lighted candles, should be placed on or near the
product.