Bush 239 / 3289, Instruction Manual

Page: 8 / 24

8
Switch on
Press and hold the ‘Power/Mode’ button. The display will fully switch on and your
Radio will return to the mode that it was last used in (DAB/FM). If you were listening to
a radio station before then this station will be automatically selected.
Note: Always make sure that the aerial is fully extended, to ensure the maximum signal
strength and the best possible sound quality.
Switch of
Press and hold the ‘Power/Mode’ button. The Radio will go into Standby mode.
To completely switch of the Radio and the display, slide the switch on the back of the
radio to ‘Of’. Switch of the mains power at the wall socket, remove the power plug
from the back of the radio. Remove the batteries, if itted.
Change the mode
Briely press the ‘Power/Mode’ button to change between DAB and FM modes. Please
check the display.
Adjusting the volume
Turn the Volume rotary control anti-clockwise to decrease the volume and clockwise
to increase the volume. When you adjust the volume, please check the display which
will conirm the volume level.
Using headphones
You can connect headphones (not included) to your radio. The headphone socket can
be found on the back of your radio and when you have headphones connected the
radio speakers are switched of and all sound is via the headphones.
Note: Headphones will need a 3.5mm stereo plug.
Changing DAB stations
1. If you are not already in DAB mode, briely press the ‘Power/Mode’ button to go to
DAB mode.
2. Turn the left hand ‘Tune/Select’ rotary control to scroll through the available
stations in the station list. When the station that you would like to listen to is
displayed press the left hand rotary control to ‘Select’. There will be a short delay
whilst your DAB radio tunes to your selected station.
Using your DAB/FM Radio
8