Bush 239 / 3289, Instruction Manual

Page: 12 / 24

12
Telescopic aerial
Please make sure that the aerial is fully extended before you attempt to tune to an FM
station. This will ensure that the maximum signal strength is available when the Radio
begins to scan. Extending the aerial also ensures the best possible sound quality.
FM Radio mode
If you are not already in FM mode, briely press and release the ‘Power/Mode’ button to
go to FM mode (check the display).
If you were listening to an FM station when you switched the Radio of then this station
will be automatically selected when you switch the Radio back on.
Tuning to an FM station
1. If you are not already in FM mode, briely press the ‘Power/Mode’ button to go to
FM mode.
2. Press and release the ‘Scan’ button on the top of your radio to scan up the
frequency band. Press and hold ‘Scan’ to scan from the start of the frequency band
and automatically store the stations found into Presets.
Note: You can overwrite the stored station presets, see page 13, Storing an FM
station preset.
3. Use the left hand rotary control to ine tune each frequency in 0.05MHz steps.
Note: If reception is still poor adjust the position of the aerial or try moving the
radio to another location.
Changing the Scan setting
In FM mode:
1. Press the ‘Menu/Info’ button. ‘Scan setting’ is displayed. Press the left hand rotary
control to ‘Select’. The current Scan setting will have an ‘*’ in the top right of the
display.
There are two diferent options to choose from:
• Strong stations - the scan will only stop when a strong signal strength is received
which should also result in a better audio quality. It is possible that the station you
are scanning for may be missed using this option.
• All stations - the scan will stop for every station it receives, even if the signal
strength is poor.
2. Use the left hand rotary control to choose from the two options available and
press to ‘Select’. Press the ‘Menu/Info’ button to return to the station display.
Using the FM radio