Bush 134082072, Instruction Manual, Page: 16 / 32

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting section of these instructions
16
Using your vacuum
Getting started
1. Before use, pull out the cable until the yellow mark on the cable is
visible. This is the ideal cable length. Do not extend the cable beyond
the RED mark.
2. Fit the correct nozzle for the cleaning application (see next page) and
plug the vacuum cleaner into the mains supply.
3. Press the ON/OFF button to start the vacuum cleaner and vacuum as
required.
4. The suction can be released quickly by
moving the suction release slider on the
top of the flexible hose handle (fig. 2).
5. To raise or lower the brushes on the
floor head (fig. 3) press or lift the floor
head adjustment lever.

When cleaning carpets, raise the
brushes on the floor head.

When cleaning hard floors, lower
the brushes on the floor head.
6. Press the ON/OFF button again to
switch the vacuum cleaner off after use
and before disconnecting the plug from
the mains supply.
7. Rewind the cable by pressing the cable
rewind button. It is advisable to guide
the cable with your hand to prevent the
cable whipping and damaging the
appliance or other household property.
If the cable does not rewind completely,
pull the cable out a small way and press
the rewind button again.
Fig. 4
Fig. 2
Fig. 3
Suction release
slider
Adjustment lever
Adjustment lever