ASSEMBLY
DSP8/10/12 10/19
Assembly Section 3-2
© 2019 Alamo Group Inc.
A
SS
EM
B
LY
Tractor Requirements
Tractor horsepower range should be between 70 to 125 HP and must be capable of controlling the Pull Type
Drag Scraper under all operating conditions. Tractors outside this horsepower range must not be used.
Your tractor may require additional ballast to maintain steering control. Refer to your
Tractor's Operator's Manual and machine weights in Operation Section to make this
determination.
The number of required hydraulic duplex outlets at the tractor is dependent upon how the Pull Type Drag
Scraper is set-up.
One hydraulic duplex outlet is required if the scraper is equipped with the standard axle.
Two hydraulic duplex outlets are required if the scraper is equipped with the tilt axle.
Dealer Preparations
This Pull Type Drag Scraper has been partially assembled at the factory. Additional assembly will be required
before the unit can be attach to the customer's tractor. Make sure the intended tractor conforms to the "Tractor
Requirements" above.
Read and understand the Operator's Manual. An understanding of how the unit works will aid in the assembly
and setup.
Torque Requirements
Refer to "Torque Values Chart" in the Maintenance Section to determine correct torque values when tightening
hardware.
Always secure heavy components with a hoist or other lifting device before removing
hardware and bands that secure the components. Heavy components can fall suddenly
causing serious injury or death.
Be sure to retain all uncrating hardware for assembly and set-up.
Summary of Contents for DSP10
