The optional Hydraulic Chute Rotator uses a hydraulic motor, controlled by the tractor hydraulics to
rotate the chute.
The kit includes:
• safety shield,
•
2 pcs 1/2”-20 UNF bolts,
•
hydraulic fittings,
• hoses with tractor couplings.
When installing the hydraulic elbows, turn them in
“no more than 4 rounds”
then tighten the jam-nut
to secure the elbow in the direction that you want the hoses to go as shown.
The relief valves are factory preset at 900 PSI.
Route the hoses and tie them to the top “A” frame support, away from moving parts, Ensure that the
hoses do not get too tight or rub on the frame when the blower is raised or lowered.
Set the motor with the bracket on top of the Chute Plate and then place the shield on top of the motor
bracket and secure with 1/2”-20 UNF bolts
Please ensure that the gear does not jam or bind during the rotation of the chute.
The bolt holes are slightly oversize, allowing you to adjust the clearance somewhat. You should be
able to move the chute back and forth slightly.
Route and secure hoses so they do not come in contact with rotating chute, PTO or get pinched in
3PH when using snowblower.
Optional Hydraulic Rotator Installation
17
Summary of Contents for 50079152
Page 2: ...Notes REV 300920 2 ...
