Bush Hog Snowblower Assembly Instructions
Parts for Assembly (78”, 87”, 97”)
• 2 pc Hood Bearing
•
4 pc 5/8” Wave-washer
(thin)
•
2 pc 5/8” x 2” UNF bolts
•
2 pc 5/8” UNF Lock nut
• 1 pc 2 Hole Chute Clamp
• 1 page Assembly Instructions
Upon Receiving the Bush Hog Snowblower
The blowers are shipped in a packaged state
Snowblowers are shipped without the chute and hand crank assembled to the unit
Carefully remove the chute and PTO shaft from the area of the snowblower auger and set them
aside. Locate the bag or package of small components.
Remove the ties that hold the plastic ring on the blower and place base of the chute on top of
the plastic ring. (Note: plastic ring can be lightly coated with grease at this time).
For the 60” and 68” Blowers take two 1/2” bolts and drop them through the holes in the chute
clamp, turn the clamp upside down while holding the bolts in the holes. Place a 1/2” wave-washer
on the bolt, then a 1/2” bearing, finish with another 1/2” flat washer. Turn the clamp right side up
with the washers and bearings on the bolts. Carefully insert the bolts into the chute base and
secure with the Lock washer and nut.
For the 78”- 97” blowers take two 5/8” bolts and drop them through the holes in the chute clamp,
turn the clamp upside down while holding the bolts in the holes. Place a 5/8” wave-washer on the
bolt, then a 5/8” bearing, finish with another 5/8” wave-washer. Turn the clamp right side up with
the washers and bearings on the bolts. Carefully insert the bolts into the chute base and secure
with the Lock nuts.
Install the PTO with the shear bolt yoke at the gearbox.
This will provide you with more space
when changing shear bolts.
Chute
Bolt
Clamp
Wave washer
Bearing
Plastic Ring
Parts for Assembly (60” , 68”)
• 2 pc Hood Bearing
•
2 pc 1/2” Wave-washer
(thin)
•
2 pc 1/2” SAE Washer
•
2 pc 1/2” x 2 1/2” UNF bolts
•
2 pc 1/2” UNF Lock nut w/Lock washer
• 1 pc 2 Hole Chute Clamp
• 1 page Assembly Instructions
!
CAUTION
Operational Hazard
Personal Protection Equipment (PPE) is
required when operating or maintaining
this machine.
15
Summary of Contents for 50079152
Page 2: ...Notes REV 300920 2 ...
