Check to see that quick draw handle has moved to
the handle engaged position by rolling quick draw
bucket or attachment back and then raising loader
boom to hood height.
NOTE: Quick draw handle must be located in the
handle engaged position. Refer to Figure 4 below
and to Figures 5 and 6 page 28.
Check that quick draw bucket or attachment is
securely attached to quick draw latch attach by rais-
ing loader boom 3 to 4 feet, dumping quick draw
bucket or attachment against stops, and checking to
be sure quick draw bucket or attachment does not
roll out of quick draw latch attach. Refer to Figure 5.
Figure 4
Figure 5
WARNING
A QUICK DRAW BUCKET OR ATTACHMENT
THAT IS NOT SECURELY LOCKED INTO
QUICK DRAW LATCH ATTACH COULD
COME OFF DURING LOADER OPERATION
CAUSING SERIOUS INJURY OR DEATH.
Inspect quick draw attaching areas to verify that
quick draw pins have engaged quick draw bucket or
attachment fully. Refer to Figure 6.
(1) Quick draw pin.
(2) Quick draw pin bushing.
(3) Quick draw bucket or attachment engaging bar.
If installing an attachment utilizing a third cylinder
hydraulic circuit, connect loader hose quick couplers
to attachment quick couplers.
Figure 6
30
