6 | Installation
10 / 20
Installation and Retrofit Instructions DOLPHIN LM 0180-0270 A, LT 0170-0220
A_EN_en
6.2.2 Install Adapter
• Use new provided gasket located on the top of the motor inline with the x4 tapped
holes.
• Taking the adaptor plate begin to position on top of the rubber gasket, carefully pass
motor wires through the center and place onto motor top where the adaptor place
will mount.
• Feed loose motor wires through opening in adaptor module, ensure the adaptor mod-
ule is in the correct orientation, with the ‘U’ section facing towards the motor fan end.
• Secure adapter once step 1 & 2 are completed, using (x 4 qty) M5 Hex Head Screw
and Spring Washers to 5Nm.
• Connect motor wires in the correct sequence as pairs on the x3 terminal pins for U, V,
W, (as per step 7.2.1) according to the shown terminal markings.
• Please carefully look at the terminal pins on the PCB board there are small identifica-
tion markings for U, V, W.
Note: Should the electrical phases not be assembled in the required direction of motor
rotation, this can be altered later if the Inverter software is provided.
Summary of Contents for LM 0180 A
Page 19: ...Note ...
