10
Installation of the system
Step 2:
Depending on the vehicle type and its equipment (e.g. airbags), it is
reasonable to install the microphone either at the A-pillar, at the sun
shield or at the roof interior. For details about the equipment features
please refer to the vehicle documents.
Step 3:
Remove or loosen up cladding and covers to be able to install all of the
cables in the vehicle as comfortably as possible. Please lay the cables
in a way that they do not lie/hang unsecured in the vehicle and that
they may not influence the conducting of the vehicle. When laying
a cable, please take care that it is not under traction stress but that it
has some tolerance. Avoid crushing the cable as damages of the insula-
tion can be caused by friction/rubbing.
Step 4:
Install the electronics box at a convenient place in the vehicle. This can
e.g. be behind the radio, in the glove box, or in the centre console.
Please mind that you can access the connections of the box without
difficulty. It is possible that you will have to connect the components
before attaching the electronics box, if it isn’t possible to do this after-
wards due to a lack of space. A description of the connections is pro-
vided in the next section.
Step 5:
The preferred position for on-glass antenna is either on the upper right
side or upper left side of the windshield, opposite from the driver´s
seat.
Important:
Ensure the antenna is located at least 20 cm away from
X
driver and passengers.
To avoid audio interference, do not thread the antenna
X
cable close to the microphone cable.
Before connecting the components to the electronics box you should
branch off the battery for safety reasons. In doing so, take into account
that there might be a radio coding (confer radio manual).
Important:
Please install the electronics box behind a cover or some-
X
where you can only reach by opening or unfastening a pro-
tective cover / a cover. The elctronics box must not hang
loosely in the vehicle.
