R
8
en
Suitable for cold and warm environments.
Other adhesives include acrylic types with much faster setting times.
Loctite Multibond
is well suited for
low temperature and fully cures in 24 hours.
Scotch-weld M2000
will reach a high strength after 30 minutes.
The suitability of any adhesive should be determined by the User. Some coatings can be adversely affected
by adhesives. Some adhesives can be contaminated by coating environments, solvents etc.
The adhesive supplied with this product must be disposed of as special waste unless it has been fully cured.
To dispose of excess adhesive at the end of its shelf life simply mix the remaining material and allow it to
cure before disposal.
For further guidance on the disposal of adhesives contact your local environmental authority.
4 DOLLIES
Dollies can be re-used after cleaning.
Large dollies
Coatings on concrete, cementatious layers and uneven surfaces can be tested more effectively with a large
dolly. This has twice the diameter and so 4 times the area of the standard dolly. The scale readings of the
Elcometer 106 must be divided by 4 to compensate.
The large dolly is taller than the standard dolly. A special base ring is used to support the instrument to
enable correct operation. The large dollies and base ring are available from Elcometer or your local supplier
- see “Spare parts and accessories” on page 12.
106_TMA_0003_00_09.fm Page 8 Tuesday, July 31, 2012 2:08 PM
106
Pull Off Adhesion Tester
10 of 12
For more information
/ 1300 287 935
[email protected] / www.burwell.com.au
