AIM-50™ Installation Manual
−
Double Ceiling Version 5000147 A01 17
Final Testing
Turn the individual wall switches on to check proper operation.
The arm system should swing easily within the range of motion as illustrated on page 6.
Adjusting Arm Tension
The spring inside the arm is pre-adjusted at the factory. If, however, the light head drifts up or
down, please refer to the Operation & Maintenance manual for guidance on how to adjust it.
Cutting the Down Tube
If shortening the down tube is required, the following procedure applies:
1.
Cut the down tube
from the top
to the appropriate length (the top of the down tube has 3
holes, the bottom has 6 holes ).
2.
Drill new holes on the top of the down tube according to the drawing below.