Burster 9186-V Series, User Manual, Page: 7 / 24

Typ 9186-VX1XX
www.burster.de 7
Display and keyboard
1 2
1
3
4 5 6 7
8
UP SHIFT
DATA
ENTER
2
RUN MODE PRO MODE
1 4 red digit Display Shows value according configuration. Shows steps and data during configuration.
2 Keyboard — —
3 Setpoint 1 LED It iluminates when Setpoint 1 turns active. It iluminates when Setpoint 1 turns active.
4 UP key
Display TARE.
TARE RESET (when pressing more than 3s). Shows Setpoints value.
Increases value of active digit.
5 SHIFT key
Displays maximum and minimum stored values.
After 3s of pressing, sets maximum and/or minimum
memorized value to current display value.
Shifts active digit to the next right digit.
Shows sequentially menu options.
6 DATA/ENTER key Changes to PRO mode.
Validates selected data and parameters.
Moves one step forward in configuration menu.
Changes to RUN mode.
7 Setpoint 2 LED It iluminates when Setpoint 2 turns active. It iluminates when Setpoint 2 turns active.
8 Free space for units label — —
There are two main function modes:
RUN and PRO . PRO mode is when
configuration menu is entered to
programm the indicator, whereas
RUN is the normal mode in which
display shows the reading according
to configuration and input signal
value.
The table below summarizes display
parts description and LEDs and
keyboard function.
Installing and connecting recommendations
WARNING: If this instrument is not installed and used in accordance with this instructions,
the protection provided by it against hazards may be impaired.
To meet the requirements of EN 61010-1 standard, where the unit is permanently connected to main
supply, its is obligatory to install a circuit breaking device easy reachable to the operator and clearly
marked as the disconnecting device.
To guarantee electromagnetic compatibility, the following guidelines should be kept in mind:
 Power supply wires should be separatedly routed from signal wires and never runned in the same
conduit.
 Use shielded cable for signal wiring.
 Cables section should be  0.25 mm² .
Before connecting signal wires, signal type and input range should be verified to be within the right
limits.
This instrument coforms with the following community directives: EMC 2004/108/CE and LVD 2006/95/CE.
Refer to the instructions in this manual to preserve safety protections.