6
GETTING STARTED
The TT40 uses a Four stroke engine
Do not Mix Oil and Gas.
Please read instructions below before fueling.
1. Fuel should be regular 87 octane pump gas only
2.Use only approved fuel container.
Make sure container is clean and dry inside
before filling with fuel.
3. Make sure that the engine is not running.
4. Open the fuel cap slowly, so that possible
pressure build-up can be released.
5. Wipe off the fuel cap area to make sure that it is free of dirt and debris.
6. Pour Gas into the fuel tank being careful not to overfill.
7. After fueling, replace the fuel cap and tighten.
8. Clean any spilled fuel off the tank and engine.
Move at least 10 feet away from where you filled up the tank to
get away from spills and fumes.
1. Set the choke to the
START
position.
2. Turn the Kill switch to the
ON
position.
3. Press the fuel primer bulb several times until you see fuel in the bulb.
4. Holding the left-hand grip, pull the starter briskly. Note: Do not allow it to snap
back, instead, let it recoil slowly.
3. You may want to give it a little throttle by slightly turning the twist throttle.
4. It may be necessary to pull start the motor several times the first time you start it.
5. Once the engine has started and run for 20 seconds, slowly move the choke
lever to the
RUN
position.
6. Let the engine warm up for a minute or two before riding.
7. When operating for the first time a 30-minute break in period is recommended.
Operate the mini bike at moderate speeds during the break in period.
NOTE:
Extended running with the choke fully on will cause the engine to run
poorly and can cause damage to the spark plug and cylinder wall.
FUELING
STARTING
