22
Basic Maintenance Procedures
To adjust the tension of the chain
1. loosen the rear axle nut. (B)
2.Loosen the brake mount bolt. (A)
3.Using a 10mm open end wrench, screw
the adjuster nuts (C) in (clockwise) a few
flats at a time.
Be sure to adjust the same amount on
Both adjuster nuts to keep the rear wheel
straight. Check the tension on the chain
again, and repeat as necessary until the
chain feels right, ½ movement.
Tighten the axle nuts on both sides to
hold it in place. Rotate the wheel and
recheck chain tension after axel nuts are tightened
To lubricate the chain, raise the rear
of the scooter up onto a block or
platform so that the rear wheel spins
freely. Then using one hand, spin the
rear wheel while spraying lube onto
the drive chain. Any standard lube
will work, but do not use a lube with
a degreaser in it, like WD40 because
it tends to dissolve the lube that is
inside the rollers, shortening the life
of your drive chain.
Your Burromax TT40 Gas Minibike comes equipped with a mechanical rear disc brake
for sure stops. It is important to be sure that the brake is working properly before each
ride. Checking functionality is simple and only takes a few seconds.
Before starting the engine, squeeze the brake handle while trying to roll the minibike
forward. The break lever should feel firm and should not touch the handle grip before
the brake engages. If the brake lever squeezes too far and feels soft, it is probably
time to adjust your brake.
BRAKES
