9
GENERAL INSTRUCTIONS
Please read the owner’s manual carefully and keep it safely. If you have any questions, we ask you to contact
your local authorized dealer.
Operating temperature
An operating temperature that is too high or too low may cause malfunctioning. We
therefore recommend letting the unit settle for a while after unpacking before connecting
and operating it.
Setting up
When choosing a place for your equipment please observe the following:
- Avoid direct sunlight.
- Do not expose the equipment to excessive heat, cold, humidity or dust.
- Provide adequate air circulation; avoid placing the equipment in enclosures.
- Slots and other openings in the housing are for ventilation. They must not be covered up.
- Please make sure that the component is not exposed to dripping water or splash water,
also don’t place boxes with liquid onto your component.
- Open flames like candles must not be placed on top of any electronic unit.
Mains voltage
Check before operating the unit to see if the mains voltage setting shown on the back panel
below the AC mains input conforms to the voltage of your household power supply. Any
changes should only be done by an expert only.
For AC connection please use only the three-pronged power cable provided.
The grounding pin should not be bypassed under any circumstances. Connect the
component only to a wall outlet with fully functional grounding pin.
Comm. operation
Before installation, switch off all other components of your hifi system. Switch them back on
only after making sure that all connections have been made correctly and completely.
Never try to operate the equipment when it has obviously been damaged or if liquid has
gotten into it.
Terminals
The pins of the connecting terminals on the back panel must not be touched under any
circumstances. Static discharges may damage the electronic circuitry inside the unit.
Interconnects
We supply custom-made balanced as well as unbalanced interconnect cables and speaker
cables of any length to ensure highest-quality signal paths for our components. The
impedance of our cables is ideally matched to all BURMESTER components.
For the cleanest power supply we recommend our triple-shielded power cord BURMESTER-
POWER.
Heat development
Be careful when touching the housing – it may get quite warm during operation.
Reset
If the unit does not react when pressing the control keys on the front panel it may be reset
to normal operation by switching it off and back on using the AC mains switch in the back.
