Strana 19 z 19
-- Too much thrust, as a result the motor is dragging.
Use less thrust during the task.
(3) Motor gets hot.
-- Foreign substances have got inside the motor.
Have the foreign substances removed.
-- Lack of or contaminated lubrication grease.
Have lubricating grease applied or replaced.
-- Pressure too high
Use less thrust during the task
(4) Frequent or strong sparks on the commutator.
-- Short circuit on the armature.
Have the armature replaced.
-- Carbon brushes worn out or jammed
Have the carbon brushes checked.
-- Rough running of the commutator.
Have the surface of the commutator cleaned or ground.
For your own safety, never remove parts or accessories of the electric tool during operation. In case of fault or
damage have the electric tool repaired only by a specialist workshop or by the manufacturer.
10. LABELS ON YOUR TOOL (if any)
V
Volts
Hz
Hertz
Alternating current
W
Watts
n
0
No load speed
/min or
min
-1
Revolutions or reciprocation per
minute
Class II tool
To reduce the risk of injury, user
must read instruction manual
Wear Ear Protection
Wear Eye Protection
For your personal safety, READ and UNDERSTAND before using.
Save This Instruction For Future Reference
Always Wear Ear Protection With This Tool
Always Wear Eye Protection With This Tool
Always Wear a breathing Mask With This Tool
11. ENVIRONMENTAL PROTECTION
Do not dispose of in general household waste. Instead dispose of in an
environmental way, contact your local recycling centre of council
for advice. Please take the care of the environment very seriously.
