Using Your Stroller
1. Loop tether around handle bar center, slide strap end
through small loop on other end of strap and tighten
securely.
PHOTO 9
2. Engage parking brake.
3. Place stroller wheel in “Stroll” position and secure by
tightening knob.
PHOTO 10
4. Slide tow bar into left tow bar mount
as far as it will go
and
then close clamp firmly, making sure clamp latch is engaged
.
PHOTO 11
NOTE:
Retaining pin is not used for the “Stroll” position.
5. Push trailer to test stroller wheel tracking. If trailer does not
roll straight, adjust wheel tracking.
To view a video clip of “Convert from Trailering to
Strolling” go to: www.burley.com/support/tutorials.cfm.
Adjusting Stroller Wheel Tracking
NOTE:
For best results, adjust with trailer fully loaded.
Tool Required:
5mm hex wrench (provided), 25mm (1”) wrench
1. With stroller wheel secured in “Stroll” position, loosen bolt
using 5mm hex wrench.
FIGURE 3
2. Using a 25mm wrench, turn bushing so that stroller wheel is
vertical when viewed from front.
3. Fine tune as necessary so that trailer rolls straight.
4. Tighten bolt.
To view a video clip of “Adjusting Stroller Tracking” go to:
www.burley.com/support/tutorials.cfm.
Tow Bar
Clamp
PHOTO 9
PHOTO 11:
Tow bar in “Stroll” position
Tow Bar
Mount
Tow Bar
PHOTO 10:
Stroller wheel in “Stroll” position
Knob
THIS PRODUCT WAS DESIGNED FOR USE ON SURFACES THAT ARE
MEANT FOR WALKING. DO NOT USE IT ON STAIRS, ESCALATORS
OR OTHER UNEVEN SURFACES. NEVER USE IT WITH INLINE OR
ROLLER SKATES. FAILURE TO FOLLOW THESE INSTRUCTIONS CAN
CAUSE AN ACCIDENT RESULTING IN SERIOUS INJURY.
WARNING
WHEN CONVERTING THIS ATTACHMENT FROM STROLLING TO
BIKING, MAKE SURE THAT STROLLER WHEEL IS IN PROPER
POSITION BEFORE ATTACHING TRAILER TO YOUR BICYCLE.
WARNING
FIGURE 3:
To adjust stroller wheel tracking
Bushing
Bolt
B U R L E Y D ’ L I T E S T A N D S O LO S T O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N UA L
7
