Using Seat Recliner
For added comfort when children are sleeping, make the
following adjustments to recline seat:
1. Loosen tension on lower horizontal strap on seat back.
2. Loosen tension on helmet pocket straps on upper back of
seat.
PHOTO 16
3. To return seat to upright position, reverse steps 1 & 2, and
make sure upper seat strap is also tightened securely.
Hitching Trailer to Your Bicycle
NOTE:
The Burley Forged Standard Hitch is used
for bicycles with either nutted axles
FIGURE 6
or
quick release assemblies.
FIGURES 7 & 8
1. Remove axle nut or rear quick release lever
assembly from bike.
2. Match hole on flat side of hitch upper arm to left (non-
chain ring side) rear dropout hole, and place hitch flat
against the dropout.
3. Loosely reassemble axle nut or quick release assembly
through hitch, dropout and wheel. Racks, bags, or fittings
should not interfere with hitch.
4. Slide flex connector between hitch side arms, and match
holes.
5. Open retaining pin and insert through hitch and flex
connector holes from above. Close retaining pin.
6. Tighten axle nut or tighten and close quick release lever,
with lever pointing to rear of bike. A properly adjusted
quick release lever should leave an imprint on your palm
when the lever is rotated to the closed position. Verify that
hitch is secure and cannot be rotated by hand.
7. Wrap safety strap twice around inside of chain stay. Fasten
hook to D-ring on underside of tow bar end.
FIGURE 8
8. To remove trailer from bicycle, unfasten clip from D-ring
and remove retaining pin.
PHOTO 16
FIGURE 8
10
B U R L E Y D ’ L I T E S T A N D S O LO S T O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N UA L
IMPORTANT
UPPER SEAT STRAP SHOULD ALWAYS BE TIGHTENED
BEFORE TRAILERING.
QUICK RELEASE LEVER MUST BE IN CLOSED POSITION AND
HITCH SAFETY STRAP PROPERLY INSTALLED. NUTTED AXLES
MUST BE TIGHTENED SECURELY. HITCH MUST NOT INTERFERE
WITH RACKS, BAGS OR FITTINGS. INSPECT HITCH AND TOW BAR
FREQUENTLY FOR DAMAGE OR LOOSE FASTENERS. DAMAGED OR
IMPROPERLY INSTALLED HITCHES OR INTERFERING PARTS CAN
CAUSE ACCIDENTS RESULTING IN SERIOUS INJURY.
WARNING
Tighten to
return seat
to upright
position
Loosen for
Reclining
Quick Release Lever
Hitch Upper Arm
Retaining Pin
Flex Connector
Hook fastened to
D-ring under tow bar
FIGURE 7:
Quick release assembly
FIGURE 6:
Nutted axle assembly
Hitch
Nut
Hitch
Nut
Quick Release
Safety strap
wrapped twice
around chainstay
