Burkert Type MS01, Operating Instructions Manual

Page: 55 / 88

55
General settings - Parameter
13.11 Disable or enable the diagnostics
•
If the diagnostics are enabled, the product gives information about the following items:
- Monitoring of the measurement values.
-
Monitoring of product-internal parameters.
- Status of the communication with the connected fieldbus.
By default, the diagnostics are enabled. The product status are shown according to Table 8 .
Table 8: Product status if the diagnostics are enabled
Product-status
indicator
Colour code
(for a PLC)
Displayed
symbol
Description Meaning
Colour
Red 5
Failure, error,
malfunction
Due to a malfunction of the product
or its periphery, the measured
values can be incorrect
Orange 4 Function check
Ongoing work on the product. For
example, simulating measurement
values.
Yellow 3
Out of
specification
At least one of the monitored
parameters is outside its monitored
limits.
Blue 2
Maintenance
required
The product is in controlled oper-
ation; however, the function is
briefly restricted.
→ Do the required maintenance
operation.
Green 1
Diagnostics
active and no
event has been
generated
Messages are listed and possibly
transmitted through any connected
fieldbus.
Flashing rapidly - - Identification
The product is selected using
a man-machine interface, for
example the Bürkert Communicator
software.
•
If the diagnostics are disabled, the product status changes are not shown. Refer to Table 9 .
Table 9: Product status if the diagnostics are disabled
Product-status
indicator
Colour code
(for a PLC)
Displayed
symbol
Description Meaning
White 0
Diagnostics
inactive
Messages are neither listed nor
transmitted through any connected
fieldbus.
Flashing rapidly - - Identification
The product is selected using
a man-machine interface, for
example the Bürkert Communicator
software.
English
Type MS01