43
Electrical installation
Type 8098 FLOWave L
8
ELECTRICAL INSTALLATION
8.1
Safety instructions
DANGER
Risk of injury due to electrical voltage.
▶
Before carrying out work on the system, disconnect the electrical power for all the conductors and isolate it.
▶
In accordance with standard UL/EN 61010-1, all equipment connected to the Type 8098 FLOWave L
flowmeter shall be double insulated with respect to the mains and all circuits connected to the Type
8098 FLOWave L flowmeter must be limited energy circuits.
▶
Observe all applicable accident protection and safety regulations for electrical equipment.
Risk of injury due to pressure in the installation.
▶
Before any intervention in the installation, stop the circulation of liquid, cut off the pressure and drain the
pipe.
▶
Before any intervention in the installation, make sure there is no pressure in the pipe.
▶
Observe the dependency between the liquid temperature and the liquid pressure for the fitting used.
If switched on for a prolonged time, risk of burns or fire due to hot device surfaces
▶
Do not touch with bare hands.
▶
Keep the device away from highly flammable substances and liquids.
Risk of burns due to high liquid temperatures.
▶
Do not touch with bare hands the parts of the device that are in contact with the liquid.
▶
Use safety gloves to handle the device.
▶
Before opening the pipe, stop the circulation of liquid and drain the pipe.
▶
Before opening the pipe, make sure the pipe is completely empty.
Risk of injury due to the nature of the liquid.
▶
Respect the prevailing regulations on accident prevention and safety relating to the use of dangerous
liquids.
WARNING
Risk of injury due to non-conforming installation.
▶
The electrical and liquid installations must only be carried out by qualified and authorized personnel with
the appropriate tools.
▶
Fit a circuit breaker or a switch to the electrical installation of the building in which the device is
installed.
▶
Install the circuit breaker or the switch in an easily accessible place.
▶
Identify the circuit breaker or the switch as the disconnecting component for the electrical power supply
to the device.
▶
Install overload devices that are appropriate for electrical installation.
▶
Observe standard NF C 15-100 / IEC 60364.
English
