15
CONTROL UNIT RIGHT SIDE
Figure – 3
Figure – 3
CONTROL UNIT LEFT SIDE
1. Before using the Burke Low Air Loss Support Sys-
tem ALTERNATING PRESSURE mattress replace-
ment system remove any non Burke Low Air Loss
Support System mattress system from the bed frame
(BF).
2.
Burke Low Air Loss Support System Mattress
Replacement system:
When using a Burke Low Air
Loss Support System mattress replacement system,
unroll the Support System mattress (B) and place it
on the bed frame (BF). Note: Make sure that the hose
end of the mattress is towards the foot of the bed.
3.
Mattress Replacement System:
There are six
nylon black straps with buckles (F), two straps at the
head of the mattress, two on the foot of the mattress,
and 2 in the middle (one on the each side of the mat-
tress) as shown. Loop each strap around the bed
frame and fasten it securely to the bed frame using
the buckle.
4. Unroll the Burke Low Air Loss Support System Re-
placement Mattress and place it on the bed frame
(BF).
Verify that the hose end of the mattress is to-
wards the foot of the bed.
Figure – 4
CONTROL UNIT REAR
5. Open the hooks (P) on the back of the
control unit (A) and suspend the control
unit from the footboard (FB) of the bed
(BF). If the bed you are using does not
have a footboard, place the control unit (A)
on its base or on its back on a flat surface
underneath the bed near the foot of the
bed frame (BF).
Care should be taken such that the
air inlet vent on the control unit is not cov-
ered, and the control unit is not placed on
the floor in such a manner that it is a haz-
ard for flow of traffic.
!
!