Plus-X Dual IP-8 Adapter Installation and Operation Manual Rev. B
3
Front Panel Indicators
Front panel of the Plus-X Dual IP-8 Adapter
Indicator
State
Description
Power LED
Off
Power is off
Power LED
Green
Power is on
Power LED
Amber
No firmware loaded (contact Customer
Support)
Power LED
Flashing
Green
Resetting to factory default settings
Link LED
Green
Connected to ARC Plus
Link LED
Off
No connection to ARC Plus
Link LED
Flashing
Green, Red
Maintenance Mode
Link LED
Flashing Red
No connection to ARC Plus, unit is in
maintenance mode
Hardware Configuration
The Plus-X Dual IP-8 Adapter is configured via its onboard web interface. Open a web browser and
navigate to
192.168.0.100
. The web page will prompt you for a username and password. Enter the
username
admin
and password
password
.
Note: The default IP address is 192.168.0.100 and the default password is “password”. If either of these
values have been changed and you do not know what they are, you need to perform a master initialization.
Press and hold the MASTER INIT button on the rear panel for three seconds. This will reset the Plus-X Dual
IP-8 Adapter to its factory default settings.
Settings
Click the
Settings
link on web page header to access the Plus-X Dual IP-8 Adapter settings. Fill out the
following fields:
IP Address
Subnet Mask
Gateway
ARC Plus IP Address
You may optionally change the HTTP and Plus-X ports of the Plus-X Dual IP-8 Adapter. The default
settings are recommended.
