Ref. “C-8 FLT O&M Manual 26-04-11” Page 7/7
3.4.4
Inspect the castors fitted to the underside of the leg frame foot rail. There should be one
at each end, totalling 4. Any missing or damaged castors should be replaced.
3.4.5
High Pressure Laminate tops with hardwood lipping:
Light scratches and / or dents to
the lipping may be repaired by rubbing down and re-staining. Scratches to the laminate
itself can be improved using a colour matched filler, but it will be impossible to match the
grain pattern.
3.4.6
Formica tops:
Scratches to the Formica surface can be improved using a colour
matched filler, but it will be impossible to match the grain pattern. Formica tops are edged
with a high impact plastic which is very resistant to damage. Any damage that does occur
will require the edging to be replaced.
•
Laminate & Formica repairs: These are specialist tasks and should only be
performed by an experienced carpenter or woodworker. If the top is more
severely damaged it will be unlikely that a satisfactory repair can be effected
and the top should be replaced.
3.4.7
Check that the linking clips are in place and rotate freely. These are fitted to two of the
four plastic corner mouldings on the underside, usually front-left and rear-right when
seated at the table. If missing or broken, the linking clips can be replaced by unscrewing
the relevant corner moulding, replacing the linking clip, then refitting the screws to secure
the corner moulding.
3.4.8
More severe damage should be referred to Burgess Furniture Ltd.
•
ANY DEFECTIVE TABLES MUST BE REMOVED FROM SERVICE IMMEDIATELY.
3.5 Lubrication
The Configure-8 Flip-Top should not need any specific lubrication.