36 | Englisch
ProfiScale MULTI PS 7455
Replacing battery
Attention!
Before opening the battery case cover of the meter, make sure that
all measurement lines are removed and the device is turned off to prevent the
hazard of an electric shock.
• If this symbol
appears on the display, the battery should be changed
immediately to prevent possible hazardous situations.
• Loosen the screw of the battery case cover on the back of the device and
remove the case cover.
• Replace the empty battery with a 9 V block battery.
• Close the battery case with the cover again and screw it down.
Replacing fuses
Attention!
Before opening the battery case cover of the meter, make sure that
all measurement lines are removed and the device is turned off to prevent the
hazard of an electric shock. Only use fuses with the required values: F1 FF 400 mA
H 600 V, F2 FF 10 A H 600 V.
• Fuses only need to be replaced rarely. A blasting of a fuse is often a
consequence to a faulty operation.
• Loosen the screw of the battery case cover and remove the battery.
• Remove the green rubber cover of the device. Loosen the four screws of the
casing and remove it.
• Replace the blown fuse with a new fuse with the appropriate capacity.
• Close the casing again and screw it down. Place the device back in the green
rubber cover again. Afterwards screw firm the battery case cover after placing
the battery.
Replacing measurement lines
Attention!
A warranty is only given when the included measurement lines are
used according to the safety standards. If required, they are to be replaced with
the help of the same model or with measurement lines of the same appropriate
capacity.
• Required capacity of the measurement lines: 600 V 10 A.
• You have to remove the measurement lines if the insulation is damaged.
Cleaning instructions
For cleaning, neither alcohol-containing (spiritus, SIDOLIN
®
or cleaners alike) nor
aggressive cleansers (acetone or likewise) must be used. Dusted or dirty surfaces
can simply be cleaned with a wet cloth.
Dirt at the pins of the measurement lines can influence the measured values. For
cleaning the measurement lines, the device needs to be turned off first and the
measurement lines need to be removed. Remove dirt thoroughly. For cleaning of
the pins, you can for example moisten a cloth with some lubricant (e.g. WD-40).
Warranty
To provide you with an impeccable and high-quality product and to optimally
help you in case of service and repair, it is necessary to hand in defective
devices at your retailer together with the original proof of purchase. For a
return according to your cancellation right, all units of the device need to be
undamaged. In a case of disregard, the warranty expires.
Disposal of the device
Dear customer,
Please help to reduce waste. If you consider to dispose of this device, please
remember that many components are made of valuable materials that can be
recycled.
We point to the fact that electronical and electronic devices, as
well as batteries are not to be disposed via the household rubbish
but need to be collected separately. Please inform yourself about
collecting points for electric waste at your local competent
authority.
For questions regarding the EG declaration
of conformity, please contact [email protected]
Printing errors as well as technical alterations reserved.
