1. Important Safety Instructions
The use of an electrical appliance requires the following common sense safety rules. Primarily there is
a danger of personal injury and secondly damage to the appliance and property. These are indicated in
the instructions by the following two conventions:-
WARNING: Danger of personal injury.
IMPORTANT: Damage to the appliance.
In addition we offer the following safety advice:
2. Installation
Preparation
•
The Installation of the unit must be performed by a competent person.
•
Remove any plastic film from the appliance and wipe over all surfaces with a damp cloth.
•
Check that the voltage shown on the rating pate is suitable for your supply.
•
Before using this appliance for the first time we recommend you clean the fryer tank with warm
soapy water. Ensuring the unit is clean and dry before use.
Location
•
Always ensure that this appliance is installed on a level, firm flat surface that is capable of
supporting the weight of the appliance.
•
Ensure the appliance is sat far enough back from the front of the work surface not to hang over
the edge and cause an obstruction.
•
Do not use this appliance outside.
•
WARNING: Do not install this appliance within 100mm of any wall, partition or kitchen
furniture.
•
WARNING: During installation do not place on surfaces or near walls, partitions or kitchen
furniture and the like – unless they are made of non-combustible material or clad with
non-combustible heat insulating material and pay attention to fire prevention regulations.
•
IMPORTANT: Do not place this appliance in an area that restricts the airflow around the front
and rear of the unit. Do not place the appliance in the direct discharge path or air conditioning
vent or make up air vent.
Fitting a plug
•
The mains lead of this appliance will already be fitted with a BS1363 13amp plug. In the event
of replacing a fuse, a 13amp fuse approved by ASTA or BSI must be used.
•
If the plug is not suitable for your socket then the plug must be cut off and disposed of safely.
•
An appropriate plug must be fitted as follows:-
•
IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:
Green and Yellow – Earth, Blue – Neutral, Brown – Live
•
The wire which is coloured Green and Yellow must be connected to the terminal in the plug
which is marked with the letter E, the earth symbol or coloured Green and Yellow.
•
The wire which is coloured Blue, must be connected to the terminal which is marked with the
letter N or coloured Black or Blue.
•
The wire which is coloured Brown, must be connected to the terminal which is marked with the
letter L or coloured Red or Brown.
•
Make sure that the connections are tight and that there are no loose strands of wire and no
insulation trapped under the terminals. Tighten the clamp in the plug making sure that it grips
the outer covering of the cord. In a 13amp (BS 1363) fused plug, fit a 13amp fuse and tighten
the plug cover securely.
