rdc-30-manual-en
Page 5 /
Carefully transport the machine to its operation site. Do not use
the motor or other extending parts as a handle.
Strip off the packing. Make sure not to damage the belt!
Mount the controller to the machine. Click into the guidance and
carefully move down to a secure position.
Connect the cables for the turning table and the stirring device.
The plugs are made in a way you cannot interchange the cables.
There is a separate cable with a European plug connected to the
bottom of the machine. This is designed to realize equipotential
for the machine body. Connect this cable to a free plug.
If you do not want to use cup glasses with diameter 80mm, you
can set a platform on top of the vessel support (compare picture
below).
Cups/Glasses/Vessels are not part of delivery!!
Composition
Maintenance
The Dip Coater RDC 30 Multidip is almost maintenance free. After each working day please clean
the guidance tracks with an oil soaked rag (resin and acid free, e.g. sewing machine oil).
Operating
Die RDC30 has a stroke length of 575mm. This is the distance the lever arm can drive between the
upper end switch and the lower end switch.
To avoid unnecessary drives, it is possible to set a virtual end switch for the dipping sequence. In
addition many customers want to have a fast speed to drive from virtual offset to the point, where
the object touches the dipping liquid and a slow speed for the actual dipping movement inside of the
liquid. For this reason there are
5
different positions to consider. From Top to Bottom:
1.
Home position (mechanical end switch)
2.
virtual end switch
3.
point of speed change (starting the actual dipping movement)
4.
bottom point dip (resting the object in the liquid)
5.
mechanical bottom end switch.
Bungard Elektronik GmbH & Co. KG, Rilkestraße 1, 51570 Windeck – Germany
Tel.: +49 (0) 2292/9 28 28 - 0, Fax: +49 (0) 2292/9 28 28 - 29, E-mail: [email protected]